This electric powered winch is ideal for indoor applications such as pulling wire through conduits or lifting equipment.
It can lift loads of 250 kg in a single line and a block and tackle system will increase the lifting capacity to 500 kg.
For lifting purposes, it is equipped with a rope grabbing system which will hold a load in position; allowing the operator to work safely.
The electric motor is activated by simply pulling on the rope. As soon as the operator stops pulling, the drum stops rotating, preventing rope damage. For the operator’s safety, it is equipped with a rope grabbing system which will prevent the rope from sliding inadvertently.
The PCT1800 is recommended for situations when gas-powered (petrol) winches cannot be used and is a good alternative when noise is an issue.
*Note: One (1) anchor polyester sling 60 mm x 2 m is always included with every winch.
Maximum pulling force with installed drum: 820 kg
Maximum pulling force with optional drum: 1000 kg
Rated lifting capacity with installed drum: 250 kg
Rated lifting capacity with optional drum: 250 kg
Installed: 85 mm
Optional: 57 mm
57 mm drum: 5.8 m/min
85 mm drum: 8.8 m/min
Lifting: Low stretch double braided polyester – unlimited length – eye splice and thimble mandatory for lifting applications
Minimum diameter: 12 mm
Maximum diameter: 13 mm
Ideal diameter: 12 mm
Engine/Motor & Gear Box
Engine/Motor: AC Electric Baldor TEFC 115/230 VAC – 1 ph – 3/4 HP – 60 Hz
Gear box and gears: Aluminium alloy gear box. Heat treated 3 stage spur gears. Shafts mounted on ball bearings. Oil bath lubrication.
Gear ratio: 110:1
Brake: Anti-reversing needle bearing
Clutch: N/A – Direct Drive
Drum turns with engine idling: No idle on electric motors
Work cycle: 25% (15 min/hour to prevent motor overheating)
Weight & Dimensions
Weight: 24 kg
Length: 55.6 cm
Width: 36.6 cm
Height: 36.6 cm
Included: Polyester sling 60 mm x 2 m (PCA-1260)
Private use: 2 years
Commercial use: 1 year
Engine/Motor: Baldor International Warranty
Certification: CE and M3 (ISO) Lifting