Description
This stainless steel swing side snatch block features two lightweight 100 mm diameter deep groove aluminum sheaves, with stainless steel plates that swing open to install rope.
Sintered bronze bushings on stainless steel shaft provides 98% efficiency.
When you use this pulley with a PCA-1274 pulley, you can quadruple the pulling power of the winches. With two double pulleys, an amazing 5 tons of force can be exerted on a load (using the PCW5000)!
The middle plate has a hole at the bottom, allowing you to attach the end of the rope with a carabiner when necessary.
Use the 70 kN steel locking carabiner (PCA-1701) to anchor the snatch block to a polyester sling.
Ideal rope diameter: 12 mm.
Specifications
Minimum Breaking Strength: N/A
Working Load Limit: 44 kN (4486 kg)
Certification: –
Material: Sides: Stainless Steel | Sheave: Aluminum
Weight & Dimensions
Weight: 2.03 kg
Diameter: 100 mm
Length: 27 cm
Width: 14 cm
Height: 14 cm
Rope
Minimum Diameter: 6 mm
Maximum Diameter: 12 mm
Warranty
Other: 1 year
Additional Information
Not designed for steel cable.
The Newton is the International System of Units unit for force; it is equal to the amount of net force required to accelerate a mass of one kilogram at a rate of one meter per second squared. The Working Load Limit (WLL) is the maximum load which should not be exceeded under any condition. The Minimum Breaking Strength (MBS) is observed during a destructive test. You should divide it by an appropriate safety factor.
